moneybags Posted October 23, 2007 Report Share Posted October 23, 2007 When setting the float hight on carbs. How high do I set them. I have a set of 35 PWK carbs and a set of 39's Do I set then the same as stock carbs? Thanks Quote Link to comment Share on other sites More sharing options...
castor927 Posted October 23, 2007 Report Share Posted October 23, 2007 all 33 up pwks' have a float height of 16mm. how to check? hold carb upside down with bowl off, lean it over untill the float is kind of in a netral position, basically not pushing down on float valve pin. from gasket surface of carb body to top of float should be 16mm. have fun! Quote Link to comment Share on other sites More sharing options...
moneybags Posted October 23, 2007 Author Report Share Posted October 23, 2007 Thanks, Now I have a reason to go work on the banshee. :biggrin: Quote Link to comment Share on other sites More sharing options...
Bansh-eman Posted October 23, 2007 Report Share Posted October 23, 2007 your sure its 16 and not 18? for some reason 18 instantly jumped into my head when i read his post Quote Link to comment Share on other sites More sharing options...
dajogejr Posted October 23, 2007 Report Share Posted October 23, 2007 Unless it's a fuel pump carb...I set PWKs to where they are level on the bottom if you flip it upside down. Make sure the spring in the needle is working too...if it's stuck in, the floats will be too low.... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.