clutch shaft bearing

[snowmanzz13]

well, some how my bearing gave out where the clutch chaft goes in from the topside of the case and i was wondering if anyone knows of how to remove it without pulling the motor and spliting the case as i would really prefer not to thanks guys

[snowmanzz13]

.... anybody?

[JKJK]

Stuff a rag in the hole to catch any debris. Then use a slide hammer with some sort of a J hook to catch the bottom side of the bearing+pound it out.Or you can carefully use a dremill tool to cut threw the bearing+race,collapse it on itself+pull it out with some needle nose pliers. Good luck those can be a real bitch.

[Bansh-eman]

with the way desribed above if you dont know wht your doing i would not try it. your bound to fuk something up.

[snowmanzz13]

well, i already removed the inner race and i still cant get the outer race out, seems very difficult.... i guess i can try an get a slide hammer with a j hook to get it out or just whip out the handy dremel and just cut the outer race since i'm half way there thanks guys

[375hp banshees]

you could try threading a bolt into the race & try jacking it out...use something bigger than the od of the race ( i'll use a 3/4 drive socket for a visual) put the socket over the hole large opening down... put a washer on top of the socket (sq. drive end) put the bolt (that you already fitted to be able to thread into the race & get a good grab ) throught the top & thread it into the race...if you get a good grab it should start to pull the race out you might have to find the right length bolt or shim it as you go... just make sure what ever you use (in place of the socket) is deep enough to alow the race to come up into it & is a large enough id to alow it also

 

good luck