sandman4free Posted January 26, 2007 Report Share Posted January 26, 2007 I have a set of 28mm oko's that I decided to install in the wifes bike, I just don't know where to start and I can't seem to get anyone who already has them to chime in. her bike has t-5's aftermarket reeds and manifold, and a k&n filter, so pretty much stock. we are right at sea level also. any help would be greatly appreciated Quote Link to comment Share on other sites More sharing options...
woodro77 Posted January 26, 2007 Report Share Posted January 26, 2007 I have a set of 28mm oko's that I decided to install in the wifes bike, I just don't know where to start and I can't seem to get anyone who already has them to chime in. her bike has t-5's aftermarket reeds and manifold, and a k&n filter, so pretty much stock. we are right at sea level also. any help would be greatly appreciated i will check mine today and let you know , i have the same mods and im at sealevel also , my carbs are 28mm oko's bored out to 30mm , not sure if that changes anything Quote Link to comment Share on other sites More sharing options...
sandman4free Posted January 26, 2007 Author Report Share Posted January 26, 2007 cool it would help me alot also while you were at it did you happen to notice what needle and clip position you are running?.....maybe I am just asking too much Quote Link to comment Share on other sites More sharing options...
woodro77 Posted January 27, 2007 Report Share Posted January 27, 2007 cool it would help me alot also while you were at it did you happen to notice what needle and clip position you are running?.....maybe I am just asking too much in the middle , , still have to check jet size , was very cold out today , Quote Link to comment Share on other sites More sharing options...
sandman4free Posted February 13, 2007 Author Report Share Posted February 13, 2007 I eneded up running a 155 main and a 50 pilot needle in the middle clip. the response is fantastic, it actually pulls harder than what I remember from stock. thank you for everyone who contributed. Quote Link to comment Share on other sites More sharing options...
LiftdT4R Posted February 13, 2007 Report Share Posted February 13, 2007 I eneded up running a 155 main and a 50 pilot needle in the middle clip. the response is fantastic, it actually pulls harder than what I remember from stock. thank you for everyone who contributed. Thanks, good to know, there isn too much jeting info for 18mm carbs on a mostly stock setup. :beer: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.