dlnoss Posted October 7, 2006 Report Share Posted October 7, 2006 A 0.130 step in the dome or is that the thickness of the squished solder? See if you can get a good deck height measurement at the edge of the piston. Quote Link to comment Share on other sites More sharing options...
AZ Erik Posted October 8, 2006 Author Report Share Posted October 8, 2006 (edited) that's about the measurement of the squish. It just barely compressed the solder doubled up like that. There is 2 pieces in the package with the domes 1 is compressed at the tip and one compressed about 1 inch into the piece. Both were compressed at the edge of the dome like here: The pistons were not even touching the solder until I doubled it up. I'll get my mic's out tonight/tomorrow. I'm guessing on the .130. it's more than double a piece of .063. I shipped the domes this morning, you should have them monday. With the only 2 pieces I could get smashed in there as well. Edited October 8, 2006 by AZ Erik Quote Link to comment Share on other sites More sharing options...
AZ Erik Posted October 10, 2006 Author Report Share Posted October 10, 2006 Piston edge to deck height measurements were 1.33mm to 1.4mm. which if I'm any good with my math puts the dome step at about 3 mm (which looks about what it was) what's the chances I have 7 mil domes? Quote Link to comment Share on other sites More sharing options...
dlnoss Posted October 11, 2006 Report Share Posted October 11, 2006 I was suspicious of that. They didn't show up today. Hopefully tomorrow. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.