BansheeBrian Posted April 13, 2006 Report Share Posted April 13, 2006 Helping a fellow brother out here on this one.He replaced the floats and needles cleaned them inside and out and it still drips when he rides.Sometimes the bowls run completely dry. I'm thinking float height issue or something just isnt seating.It's riding season again and I want to get his banshee rolling again and problem free. Any suggestions..fire away! Quote Link to comment Share on other sites More sharing options...
dajogejr Posted April 13, 2006 Report Share Posted April 13, 2006 I'd say he needs to re-clean the passage way for the fuel from the intake spout, (Compressed air does wonders) make sure the rubber tip of the needle isn't damaged, make sure the needle can move freely within the hole (yeah...that sounds bad...) and then check for correct float height. 21mm if I remember correctly, needle seated position, measuring from the base of the gasket surface to the top of the float (Flat spot when turned upsidedown) Good luck...I still think it's dirt or sumthin.... Quote Link to comment Share on other sites More sharing options...
wesw Posted April 13, 2006 Report Share Posted April 13, 2006 might also clean the fuel pitcock in the tanks. sounds like its somewhat clogs with crap. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.