Brian G Posted August 17, 2004 Report Share Posted August 17, 2004 Guys, I cannot find my damn manual!!! do any of you know what the torque is for the flywheel nut? I think it is 40 lbs but I am not sure, If any of you know I would really appriciate your help. Thanks Quote Link to comment Share on other sites More sharing options...
banshee04le Posted August 17, 2004 Report Share Posted August 17, 2004 59ft/lb playa. Quote Link to comment Share on other sites More sharing options...
Brian G Posted August 17, 2004 Author Report Share Posted August 17, 2004 Thanks!!! Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted August 17, 2004 Report Share Posted August 17, 2004 i just tighten it down with an impact till it wont move anymore Quote Link to comment Share on other sites More sharing options...
yama_banshee Posted August 17, 2004 Report Share Posted August 17, 2004 i just tighten it down with an impact till it wont move anymore ive done that before and had bad results but you should probally use a 80lb tourque stick when tightening it down Quote Link to comment Share on other sites More sharing options...
banshee04le Posted August 17, 2004 Report Share Posted August 17, 2004 80lb tourque stick Quote Link to comment Share on other sites More sharing options...
J-Madd Posted August 17, 2004 Report Share Posted August 17, 2004 I tightened mine with a ratchet by hand, then hit it with a hammer............been riding like a maniac and it hasn't popped off..... Quote Link to comment Share on other sites More sharing options...
nater006 Posted August 18, 2004 Report Share Posted August 18, 2004 Strap wrench to hold it, and a 1/2" drive 150 ft/lb torque wrench to snug it to spec. Quote Link to comment Share on other sites More sharing options...
ledofthezep Posted August 18, 2004 Report Share Posted August 18, 2004 Tight & then a little. Works for me... Quote Link to comment Share on other sites More sharing options...
racer Posted August 18, 2004 Report Share Posted August 18, 2004 i just tighten it down with an impact till it wont move anymore i did that last time i replaced my timing plate and now it wont come off. at all. just stripped my puller tryin to get it off. f*ck. anyone know if it can be safely warmed with a torch to loosen the fit a little? Quote Link to comment Share on other sites More sharing options...
Paywon87 Posted June 21, 2021 Report Share Posted June 21, 2021 On 8/18/2004 at 7:11 AM, nater006 said: Strap wrench to hold it, and a 1/2" drive 150 ft/lb torque wrench to snug it to spec. Then a 1/4 turn? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.