ewetzell Posted May 25, 2004 Report Share Posted May 25, 2004 alright i have a 93 banshee with jd ported cylinders wiseco p.8 pistons, bored carbs clamp on k&n's with 27.5 pilot 360 main and toomey needles in fourth down from top cpi inframe pipes runnin at 0- 500 on the oregon coast 18cc cool head the first 5/8 of throttle runs like a raped ape but stumbles and misses on top end and wont wind out i have tried jets from 340 to 400 and this has had no effect on the hesitation new coil rewound stator any other ideas, thanks Quote Link to comment Share on other sites More sharing options...
ledofthezep Posted May 25, 2004 Report Share Posted May 25, 2004 Choke tube in place? Torrs disconnected? Did you set the gap on the stator's pickup coil? Quote Link to comment Share on other sites More sharing options...
ewetzell Posted May 25, 2004 Author Report Share Posted May 25, 2004 choke tube good,no tors hate them damn things, will check gap on stator pickup, man am i getting mixed jetting from local people for wht i should have for those pipes. but the jetting doesnt seem to have any affect. Quote Link to comment Share on other sites More sharing options...
ledofthezep Posted May 25, 2004 Report Share Posted May 25, 2004 If you've tried that many different jets and had the same results each time...it's not going to be a jetting issue. Just MHO... Sounds electrical to me, check that pickup gap & see what you got; hopefully that's it. Quote Link to comment Share on other sites More sharing options...
frocashmoney24 Posted May 25, 2004 Report Share Posted May 25, 2004 does it have a nice thick fat blue spark? Quote Link to comment Share on other sites More sharing options...
RK Tek Posted May 25, 2004 Report Share Posted May 25, 2004 Your compression ratio is too high....causing your top end to stagnate.. You could back off the timing or get some lower compression domes. Kelsey Quote Link to comment Share on other sites More sharing options...
ewetzell Posted May 27, 2004 Author Report Share Posted May 27, 2004 checked gap in pick up coil, replaced plug caps and plugs just gotta change over paddles and terrorize the neighborhood tommorow lol will let you guys know thanks for the help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.