Jump to content

A Arms


Recommended Posts

I'm planning on setting up a banshee to race mx and am going to get some +2 Ugly A Arms to put on it. I'm plainning on putting on Elka shocks later but am wanting to hold off on the shocks until i get some more money this summer. Could i still use the stock shocks with the +2 A arms?

Link to comment
Share on other sites

tighten the adjustment on the bottom of the shock, that'll help stiffen a little.

This will add more "pre-load" and may help slightly, but ultimately the original front shocks will be far to soft both in spring rate and valving. When increasing the width of the a-arms an increase in spring rate is needed to gain back the original wheel rate, this can only be acomplished by going to a set of aftermarket front shocks (the original Banshee front springs are not replaceable for an increased rate spring) the increase in spring rate typically needs a change in valving inside the shock to controll the new spring rate.

 

BTW - I have no personal experience with the "ugly" a-arms but there have been numerous posts regarding their poor quality and customer service. Good luck.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...