906BANHSEE Posted June 5 Report Share Posted June 5 Ok so I recently just rebuilt my banshee it is a 421 assassin and I got everything together It will start up first or second kick but then require throttle to keep it idling and if you let off it will die almost immediately we have leak down tested it on the bench lost zero psi in 15 minutes we compression tested it and it’s doing 130 in both Cylinders we’ve OHM tested every electrical component and it is all within spec i’ve set the bowl heights and clean the carbs very thoroughly they are 33 mm PWK’s The air screws don’t change anything the idle screws don’t change anything the pilot jet is a 52 I’m not to sure what it could even be at this point any help will be very much appreciated Thank You Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted June 5 Report Share Posted June 5 Can you adjust the cable more... to verify its just a slide hight issue? Quote Link to comment Share on other sites More sharing options...
906BANHSEE Posted June 5 Author Report Share Posted June 5 Thanks for the reply I’ll go and double check the throttle cable and slide height Quote Link to comment Share on other sites More sharing options...
906BANHSEE Posted June 5 Author Report Share Posted June 5 I will also add there is a lot of white smoke Quote Link to comment Share on other sites More sharing options...
906BANHSEE Posted June 5 Author Report Share Posted June 5 Thank you it was the slide height 👍🏼👍🏼 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.