banshee4L Posted April 3 Report Share Posted April 3 Hello everyone hope all is well! I have a 2004 350cc banshee motor full stock(other than stator it is aftermarket) So basically, I just recently(today)changed the flywheel/stator. Before i changed it one cylin was giving more spark than the other. Now they both throw the same spark. But, one cylinder isn’t firing, it releases pressure(similar to a gust of wind) but isn’t firing. When I turn on the bike one cylin fires in which it becomes warm, but the other side doesn’t. What could it be? PS: My thoughts are it could be the carb or reed. Because when I first put the new flywheel/stator and started it both cylinders were firing(assuming by the sound) but when I turned it off after about 10-30 min I went to start it back, when one cylinder started to not fire again. Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted April 3 Report Share Posted April 3 Switch wires & plugs ( 1 at a time) to see if prob. Follows. if not, clean carb(s), check pick up gap Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.