KEVPOPPAPUMP Posted December 19, 2003 Report Share Posted December 19, 2003 What is the special tool that I need to remove the clutch arm pilot bearing in the top half case? I have been pounding for hours and the race is still not budging. The only thing that I have managed to do is really mess up the clutch arm bore's smooth finish with screwdriver pitts and gouges Quote Link to comment Share on other sites More sharing options...
SDD Posted December 19, 2003 Report Share Posted December 19, 2003 Use a dremel and cut the race. Don't bother trying to rip it out as your more likely going to mess something up. Once you grind down almost all the way through the race you can normally just twist it and it should split and fall right out. Quote Link to comment Share on other sites More sharing options...
KEVPOPPAPUMP Posted December 20, 2003 Author Report Share Posted December 20, 2003 ok will try Quote Link to comment Share on other sites More sharing options...
thebloker Posted December 20, 2003 Report Share Posted December 20, 2003 I had the same experience that you are in the process of. I had to take my case to a machine shope to get it out. Putting it in was just as bad. I tried freezing the bearing with dry ice and heating the case, but that didn't work either. Well, back to the machine shop it went. Quote Link to comment Share on other sites More sharing options...
rebelbanshee2 Posted December 20, 2003 Report Share Posted December 20, 2003 after ripping the rollers out i used Mr propane for a little bit then just put a screw driver on that little lip and tapped it out Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.