Jump to content

A-Arm bushing change...


Recommended Posts

The lower A-arm bushings on one side are shot. Just one side but I need this bike going today so don’t have time to disassemble everything.

Wondering if I can change the A-arm bushings without removing the hub assembly again.

Figured if I remove the lower shock retainer and pull the bolts from the lower arm, I can drop it enough to replace.

Or is it essential that I remove the spindle, and disassemble everything?

 

On a side note... bolts were stuck in steel tube. Used a length of threaded rod (5/8-18 [fine thread]), 3.5” long with a nut on either end. Used a steel shim on either end and loosed the nuts to wedge between the two lower swing arm bolts. Then just turned the end bolts counter clockwise until one popped loose then the other.

 

 

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

I don't see how you can do it without pulling the motor.

It was easy. Just had to remove the swing arm, handlebars and the leather tassels, hit it with my purse, drink 18 wine coolers (fuzzy navel flavor) and it was done.


Sent from my iPhone using Tapatalk
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...