Banshee508 Posted January 19, 2021 Report Share Posted January 19, 2021 I just received my new pistons in an one has a small mark at the top around the edge would this cause a issue or not thanks Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
caleb90 Posted January 19, 2021 Report Share Posted January 19, 2021 run it Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted January 20, 2021 Report Share Posted January 20, 2021 Looks like it got dropped. Does it feel out of round in that spot? Quote Link to comment Share on other sites More sharing options...
Banshee508 Posted January 20, 2021 Author Report Share Posted January 20, 2021 It is a little off in that spot but its not rough and can’t catch my finger nail on it. but im just worried about reliability being a issue Quote Link to comment Share on other sites More sharing options...
Banshee508 Posted January 23, 2021 Author Report Share Posted January 23, 2021 And i got it with my cylinders from being bored an they say that one was fitted to my cylinder so another one isnt Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted January 23, 2021 Report Share Posted January 23, 2021 3 hours ago, Banshee508 said: And i got it with my cylinders from being bored an they say that one was fitted to my cylinder so another one isnt I could tell that by the "L" marked on it. I'd at least use some fine sand paper and off the highs left from that dent. Quote Link to comment Share on other sites More sharing options...
Banshee508 Posted January 23, 2021 Author Report Share Posted January 23, 2021 So if i do lightly clean it up an use it it wont cause issues later down the road like blow by in that spot Quote Link to comment Share on other sites More sharing options...
kawa110 Posted January 23, 2021 Report Share Posted January 23, 2021 The rings create the seal. Piston just a slug moving up and down. Ensure area on piston doesn’t hit sleeve. Sand any high spots as suggested. run it Quote Link to comment Share on other sites More sharing options...
caleb90 Posted January 23, 2021 Report Share Posted January 23, 2021 9 hours ago, Banshee508 said: And i got it with my cylinders from being bored an they say that one was fitted to my cylinder so another one isnt they were both fitted to one cylinder each. the one with the l is for the left the other the right. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.