Respect Posted July 1, 2019 Report Share Posted July 1, 2019 So I was "told" the right front hub was worn out. I pulled both, which needed bearings. The studs are good too. No unusual wear inside, bearings were tightly seated. One rotor wouldn't seat 100% so upon further investigation I noticed hubs were not the same. I need a gameplan?!? Quote Link to comment Share on other sites More sharing options...
97Screamer Posted July 1, 2019 Report Share Posted July 1, 2019 I've got a set of stock hubs off my bike I'd sell for $25 shipped if you're interested. They are spray painted red but have good bearings, I pulled them off for billet hubs. Quote Link to comment Share on other sites More sharing options...
Respect Posted July 2, 2019 Author Report Share Posted July 2, 2019 Already have bearings but that would solve my problem Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted July 2, 2019 Report Share Posted July 2, 2019 J-arm hubs, rotors, and rotor mounting bolts are different from A-arm parts Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted July 2, 2019 Report Share Posted July 2, 2019 1 Quote Link to comment Share on other sites More sharing options...
Respect Posted July 2, 2019 Author Report Share Posted July 2, 2019 Yep that's it that's the difference thank you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.