ZIGGYBAM Posted May 31, 2018 Report Share Posted May 31, 2018 My motor is on its way back from HJR, and i cant wait to try it out...4mm with an mx/trail port and new hd clutch springs, domes, gaskets, a few bearings, a new stator and flywheel, a shift shaft...hoping to gain some more noticable power and some more on the low end....quick turn around too...ive never sent a motor out, so i was a little nervous, but HJR was really good thru the whole process. Quote Link to comment Share on other sites More sharing options...
Ayesully810 Posted May 31, 2018 Report Share Posted May 31, 2018 sweet. good luck. if your coming from a stock motor the gains will be night and day. keep us posted Quote Link to comment Share on other sites More sharing options...
n2otoofast4u Posted May 31, 2018 Report Share Posted May 31, 2018 Id check squish and comp before running.... Just my .02 Quote Link to comment Share on other sites More sharing options...
Ayesully810 Posted May 31, 2018 Report Share Posted May 31, 2018 1 minute ago, n2otoofast4u said: Id check squish and comp before running.... Just my .02 comp.. the computer? chip inside the electrical? Quote Link to comment Share on other sites More sharing options...
ZIGGYBAM Posted May 31, 2018 Author Report Share Posted May 31, 2018 Yes its coming from a fairly stock motor with stock carbs(no tors)...other than open k&n’s and a timing plate (+4)...im running t5’s as well.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.