Super techniplate to R50?

[hotrodbanshee]

Just rebuilt my motor after running it 5 years or so. I’ve been using Klotz super techniplate mixed at 36:1 avgas 100LL. I had a lot of carbon buildup in my pipes and pistons were black on the skirts and couple rings stuck. Really gummy residue on pistons. I have done a lot of searching and found out that castor will cause this. So I’m now Looking for a cleaner burning 2 stroke oil. Will switching to Klotz R50 full synthetic cut down on this problem. 

Edited November 28, 2017 by hotrodbanshee

[trickedcarbine]

Castor on a good mix and tune creates a light gold film on everything. I dig it, but most of the castor tends to go sticky. I've switched to. Blendzall and fucking love it. Super clean for a Castor. 

[trickedcarbine]

http://www.blendzall.com 

[special06shee]

Ive ran r50 forever. Im a fan of all klotz oils. From my experience most of the time build up comes from poorly tuned motors.

[ClaudeMachining]

100LL + Castor927 after about 600Litres

 

 

 

Envoyé de mon SM-G935W8 en utilisant Tapatalk

 

 

 

[ginger]

i have been running techniplate again because my 927 kept separating and when i would start it, it would fill the carbs with oil. 

 

[hotrodbanshee]

After further research I’m thinking 🤔 of trying the Motul 800 2T 100% synthetic oil and mixing it at 40:1

[specialblend07]

It's all oil.