jmross Posted September 12, 2017 Report Share Posted September 12, 2017 (edited) My primary gear is grooved at the seal fit. I saw you can order it separate from the clutch basket. The manual says something about gear mesh and numbers on the gears. But there is only one part number and no adjustment. So if the new gear does not have proper back lash.....then what? If I should buy them together I figure I might as well go with straight cuts for the price. This is going on a driveline high port 4mm. Thanks Edited September 12, 2017 by jmross Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted September 12, 2017 Report Share Posted September 12, 2017 Buy a matched set Quote Link to comment Share on other sites More sharing options...
jmross Posted September 16, 2017 Author Report Share Posted September 16, 2017 Do i need to run the convex washer behind the cushion plate? Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted September 17, 2017 Report Share Posted September 17, 2017 I do, but I know a lot of fella's who chuck them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.