arena314 Posted October 17, 2016 Report Share Posted October 17, 2016 will I be fine with running 25 pilots and 280 mains with foam filter no lid and t5's? I have 30's and the're to big it runs way rich down low so will the 25's work? I'm at about 50 ft above sea level at most. thanks Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted October 17, 2016 Report Share Posted October 17, 2016 Get some 27.5's Quote Link to comment Share on other sites More sharing options...
arena314 Posted October 17, 2016 Author Report Share Posted October 17, 2016 I am but I'm going riding soon they won't be here in time. is it going to be to lean with 25's? I put them in and it sounds great and my air screws are only 1 turn out Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted October 17, 2016 Report Share Posted October 17, 2016 No local shop to get some? Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted October 17, 2016 Report Share Posted October 17, 2016 Better to be rich then lean. If you're not lugging the bike off idle and stay sort of in the throttle and keep the motor fed with the needle at slower speeds you could be ok. Quote Link to comment Share on other sites More sharing options...
arena314 Posted October 17, 2016 Author Report Share Posted October 17, 2016 no the only places near me are dealers. with the 30's it took me 100 kicks to get it running cold and the air screw was only half a turn out. shee started right up with the 25's Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted October 17, 2016 Report Share Posted October 17, 2016 Try the 30's with the air screw at 2-2 1/2 turns out. Let some air at em. Quote Link to comment Share on other sites More sharing options...
arena314 Posted October 17, 2016 Author Report Share Posted October 17, 2016 the more I turned it out the less it ran I had it 1.5 turns out and it wouldnt run it would only run with it 1/2 a turn out Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
Dion27 Posted November 7, 2016 Report Share Posted November 7, 2016 Air screw in runs richer and out leaner. Was it overfueling at idle with 30 pilot? Did you have bog at idle to 1/4 throttle? Can go up to 3 full turns out on air screw, still too rich around idle at 3 out and go down pilot and start air screw back at 1.5 turns again. Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
arena314 Posted November 12, 2016 Author Report Share Posted November 12, 2016 it's idling good with the 25 pilots at 1.5 turns out I just don't know if that's too lean at 50 ft above sea level Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
arena314 Posted November 12, 2016 Author Report Share Posted November 12, 2016 (edited) it sounds healthy at idle Edited November 12, 2016 by arena314 Quote Link to comment Share on other sites More sharing options...
arena314 Posted November 13, 2016 Author Report Share Posted November 13, 2016 i put the 30's in and it bogs off idle so I think it's too big. I think I should go down to a 27.5 pilots and put the needle down 1 position bc it's 1 position up from the middle right now. thoughts? Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted November 16, 2016 Report Share Posted November 16, 2016 How many cfm are you sinking carbs to when slides are at idle stop Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted November 16, 2016 Report Share Posted November 16, 2016 Every bike is different, I've ran 25s on certain motors Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted November 16, 2016 Report Share Posted November 16, 2016 i put the 30's in and it bogs off idle so I think it's too big. I think I should go down to a 27.5 pilots and put the needle down 1 position bc it's 1 position up from the middle right now. thoughts? Sent from my SM-G935T using Tapatalk What exactly do want to hear? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.