Junksheerider Posted September 9, 2016 Report Posted September 9, 2016 Trying to get my jetting set right and can't get my banshee to idle. The motor is stock, just did a complete rebuild, stock carbs, running an air box without lid with flopro adapter and k&n filter. I'm at 719' asl. I have vforce 4 reeds on the way for it. Right now my jetting is a 30 pilot 1.5 turns out on the air screw and 280 main. It had a 25 pilot and 290 main when I got it. Torrs is bypassed and the idle screws are in 8 turns from flush with the inside of the carb body, and I still can't get it to idle very good when warm and has a slight bog. Smokes a lot at idle but runs great above a quarter throttle. Ran the same way with 25 pilots and 290 mains. When I adjust the air screws it doesn't seem to make any difference. Any ideas for me? Thanks Quote
RIPPIN' IT UP Posted September 9, 2016 Report Posted September 9, 2016 Are the slides in the right way? Sent from my ZTE T84 using Tapatalk Quote
Junksheerider Posted September 9, 2016 Author Report Posted September 9, 2016 Yes the ramp part of the slide is toward the air box Quote
Junksheerider Posted September 9, 2016 Author Report Posted September 9, 2016 It also has fmf gold and power core 2 silencers Quote
RIPPIN' IT UP Posted September 9, 2016 Report Posted September 9, 2016 That 30 pilot might be a bit big until you put the vforce 4 reeds in. Sent from my ZTE T84 using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.