arena314 Posted August 1, 2016 Report Share Posted August 1, 2016 so the right pipe on my banshee gets hotter then the left one. not much hotter but just enough to tell that it's definitely a little hotter. the quad has a fresh rebuild with only a few hours on the top end and the carb slides move up and down evenly. they both smoke about evenly but I think the left side might actually smoke a little more. my plugs look to be burning evenly also. could it be the right side is getting a little less fuel? also when I was putting the bike back together I saw that the vf4 reeds it had on it on one of then was completely closed and tbe other had a very small gap between the pedals I'm sure that can be the issue too? I don't remember what side had the open pedals though. the bike idles well and runs strongs. starts 1st or 2nd kick cold every time. thanks for any replies that's how the plugs look. right plug is right cylinder left is from left cylinder Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted August 1, 2016 Report Share Posted August 1, 2016 Did you use a synch tool? How about a radar gun to get temps? Quote Link to comment Share on other sites More sharing options...
arena314 Posted August 1, 2016 Author Report Share Posted August 1, 2016 I haven't done either but the slides are dead even Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
Ayesully810 Posted August 1, 2016 Report Share Posted August 1, 2016 Try checking your reeds too. were they chipped or any pedals missing? I had this happen recently. there were some other symptoms that I had as well that pointed to the reeds but what you are experiencing was one of them. Just a thought Quote Link to comment Share on other sites More sharing options...
arena314 Posted August 1, 2016 Author Report Share Posted August 1, 2016 1 was perfect the other looked like there was some space the pedals were a bit worn Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
Ayesully810 Posted August 1, 2016 Report Share Posted August 1, 2016 check plug caps and wires too on the side that isnt getting hot. Pics of your reeds might give a better understanding of what your talking about too Quote Link to comment Share on other sites More sharing options...
arena314 Posted August 1, 2016 Author Report Share Posted August 1, 2016 well everything is together right now and I don't have pictures of the reeds but I held them both up to a light and 1 didn't let any light through at all and the other one did so I'm assuming that one needs replacing. would worn reeds cause this issue? Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
arena314 Posted August 2, 2016 Author Report Share Posted August 2, 2016 I dont think any of the seals could be my issue because there all brand new although it's still a possibility. I think I'll start by throwing a set of new plugs in and then switching the wires to see if that changes anything Sent from my SM-G935T using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.