Rommel Posted May 16, 2016 Report Share Posted May 16, 2016 Same camber prob with my albas my left side is adjusted about half way to get my 1/8 camber and right side is adjusted right out to get same camber was bit worryed that shaft of the balljoint wasnt going past the nylock i think i have a bent right spindle Sent from my LG-E425f using Tapatalk Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted May 16, 2016 Report Share Posted May 16, 2016 If possible it would be better to thread a joint in rather than thread the opposite out. 1 Quote Link to comment Share on other sites More sharing options...
1993_banshee Posted May 16, 2016 Author Report Share Posted May 16, 2016 @Rommel I'm thinking it's a bent spindle too for mine everything Is pointing in that direction. 1 Quote Link to comment Share on other sites More sharing options...
1993_banshee Posted May 16, 2016 Author Report Share Posted May 16, 2016 Go back through and check that the bottom ball joint is screwed all the way in on both I thought for sure mine were and I went back and sure as shit they the add on two times more on right and 3 times on the left. They appear to be alot better but still a little off so I called alba themselves talked to Cory (cool guy btw) he told me they all have a little variance and for them both to be a little different from there is ok as long as they are straight. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.