Kill switch replacement question

[Oldskool83]

My kill switch shit the bed, funny how they work one day and next they don't.  It cased the bike to have no spark.  I unhooked the wires and I had spark again. I already had installed a new coil and stator and it ran good before so I know that didn't go bad over night lol.

 

My question:  Is there good replacement aftermarket?  I road the other week and had to just let the clutch out to stop it.

 

I know for sure the one I had one was off a 01 YZ250F I had left over from parting out.  I removed all the torrs junk and soldered all connections properly from my harness so I only have kill switch, coil and wires to make it run.  No key, just kick and go like a dirt bike.

 

Just wanted to add the extra information before everyone says to check all that stuff.  I am just after a new kill switch to replace the one I had go bad.

 

Thanks in Advance.

Edited December 1, 2015 by Oldskool83

[ClaudeMachining]

Kill switch, non tether, are cheap, i bought one for like 10$.

 

Tether are like 35$

Edited December 1, 2015 by Corgster

[Oldskool83]

Thanks I saw new YZ ones for $9.75 shipped.  Mine my of shit the bed due to placing the tie down clamp on my bars now that i think about it since it had no issues before the haul.  I prob pulled a wire out.

 

Thank you.

[sheerider11]

Tether.

If you ever want to race in an event they are required. Plus you look like a fool if you fall of a bike and it keeps chugging along. Or worse and run yourself over and the throttle takes off.

I have a pro armor that I can access the contacts and clean them if I ever have a problem. Haven't in 2 seasons.