landonschmidt Posted November 18, 2015 Report Posted November 18, 2015 Stock cyls. No port. Fresh wiseco topend. Stock carbs. Fmf expansion chambers with stock silencers. K&n filter without lid. Im at 500-1000ft above sea level. Would 280 mains be good starting point? What about pilots...? Sent from my LGLS990 using Tapatalk Quote
locogato11283 Posted November 18, 2015 Report Posted November 18, 2015 280 mains should be a good start. 27.5 pilot. Needle clips in the middle. Fine tune from there. Quote
landonschmidt Posted November 18, 2015 Author Report Posted November 18, 2015 280 mains should be a good start. 27.5 pilot. Needle clips in the middle. Fine tune from there. Gotcha.. I tried uploading a vid of it idling, but its not gonna let it happen.My next question. If i leave air box lid on, how lean will it actually run with just head pipes. Safe? Not safe? I do not have stock air filter and i had to modify stock silencers to fit fmfs EC's..so either i run it as is or, it sits in the garage Sent from my LGLS990 using Tapatalk Quote
locogato11283 Posted November 18, 2015 Report Posted November 18, 2015 You don't want to be lean at all. With those specs I doubt you will be lean at all. The pilot should be right on but the main may take some fine tuning to get it right on. Quote
landonschmidt Posted November 24, 2015 Author Report Posted November 24, 2015 Well short story shorter..i got my 280 mains today (still waiting on the pilots). I decided to try the mains out, see how it runs with those. 20min later..mains installed and, airbox removed.. ..i started her up! Shee ran fine. Til i gave her a bit of throttle, thn the left cylinder quit firing! I started her up again and when i blipped the throttle, the left cyl wants to quit firing....#!!#! But i discovered i can pull the choke out and the left cyl will start firing again...anybody ran into this before? I will be cleaning that carb again, when tomorrow comes.. Anything i should look for? Sent from my LGLS990 using Tapatalk Quote
landonschmidt Posted November 24, 2015 Author Report Posted November 24, 2015 And i know nothing about syncing the tors system... Last shee i had ddnt have tors. Sent from my LGLS990 using Tapatalk Quote
wayne_smith97 Posted November 24, 2015 Report Posted November 24, 2015 im thinking sync is off Ten points for doobs Quote
lil Doobie420 Posted November 24, 2015 Report Posted November 24, 2015 tors delete.. ftw. does the left cyl only die out when u hit the gas? or on idle also? Quote
lil Doobie420 Posted November 24, 2015 Report Posted November 24, 2015 change plugs first and also broken reed could be a problem. Quote
landonschmidt Posted November 24, 2015 Author Report Posted November 24, 2015 tors delete.. ftw. does the left cyl only die out when u hit the gas? or on idle also?I started it up and it idled great for a minute or 2.. Than i blipped the throttle a couple times and left cyl quit firing so i yanked the choke out and blipped th throttle again and it started firing again. Has brand new topend with about 1.5 gallons of fuel through it. It ran superb till i changed the jets.. Sent from my LGLS990 using Tapatalk Quote
landonschmidt Posted November 24, 2015 Author Report Posted November 24, 2015 change plugs first and also broken reed could be a problem.I hav new plugs that im going to run tomorrow. I did swith the plug boots around and still had same prob. So that cancels out electrical. Sent from my LGLS990 using Tapatalk Quote
lil Doobie420 Posted November 24, 2015 Report Posted November 24, 2015 go thru the carbs again I've had jets come loose and do somthing like that. make sure all jets are spotless. Sent from my LGLS740 using Tapatalk Quote
lil Doobie420 Posted November 24, 2015 Report Posted November 24, 2015 report back.. Sent from my LGLS740 using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.