Stevenhaines02 Posted August 20, 2015 Report Share Posted August 20, 2015 i bought all new cylinder alignment pins.... Like a dumbass i thought i could just grab the old shitty ones with a pair of channel locks and twist em out... Now thier out of round and tore up but still stuck. I know i know i should have just left em and only replaced the one i was missing, but the damage is done. What are your guys suggestions for getting these suckers out? Thanks Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted August 20, 2015 Report Share Posted August 20, 2015 Light amount of heat followed with penetrating oil. Repeat a couple times. Grab it with vice grips or channel locks and give it a good spin before trying to tug it like a molar. Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted August 20, 2015 Report Share Posted August 20, 2015 Also DO NOT PRY AGAINST THE BASE OF THE CYLINDER. Quote Link to comment Share on other sites More sharing options...
Zillaguy Posted August 20, 2015 Report Share Posted August 20, 2015 Put a bolt inside of the line up pin, then squeeze it so it doesn't get smashed. That way you can beast grip it, and it won't smash flat. Quote Link to comment Share on other sites More sharing options...
BANSHEE HP Posted August 20, 2015 Report Share Posted August 20, 2015 im assuming the stud is still in the case Quote Link to comment Share on other sites More sharing options...
Stevenhaines02 Posted August 20, 2015 Author Report Share Posted August 20, 2015 Studs are still in the case Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.