4mil89 Posted June 9, 2015 Report Share Posted June 9, 2015 TRYING TO DETERMINE WHAT THE INSIDE DIAMETER OF THE A/J ARM BUSHING IS OR THE METAL SLEEVE THAT SLIDES INSIDE THE BUSHING WHAT ITS OUTSIDE DIAMETER IS. HOPEFULLY SOMEONE HAS ONE LAYING AROUND SOMEWHERE THANKS KEVIN Quote Link to comment Share on other sites More sharing options...
4mil89 Posted June 10, 2015 Author Report Share Posted June 10, 2015 BUMP PLEASE Quote Link to comment Share on other sites More sharing options...
JKJK Posted June 11, 2015 Report Share Posted June 11, 2015 outside of bushing is 21mm inside of sleeve is 20.90 Quote Link to comment Share on other sites More sharing options...
4mil89 Posted June 11, 2015 Author Report Share Posted June 11, 2015 sorry for the confusion i need the inside diameter of the bushing and the outside diameter of the sleeve that slides through the center of the bushing ______1 1 ________________________ 1 _ _ _ _1 1 _ _ _ _ 1 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 1 _ _ _ _ _ 1______1 1 1_______________________1 1 1 ^BUSHING ^ SLEEVE THAT GOES INSIDE THE BUSHING HOPE THIS HELPS Quote Link to comment Share on other sites More sharing options...
JKJK Posted June 12, 2015 Report Share Posted June 12, 2015 The inside of the bushing is aprox 10 mm.The only thing that goes through the bushing is the bolt that holds the a arms on.Are you talking about the end caps that sandwitch the arms inbetween the mounting points? Quote Link to comment Share on other sites More sharing options...
4mil89 Posted June 12, 2015 Author Report Share Posted June 12, 2015 As seen in this link there are delrin bushings that press into the ends of all the arms. then there are steel sleeves that slide through the middle of all the bushings. theres short ones for the lower control arms and longer ones for the upper arms. after these are slid through the middle of the bushings then the end caps can go on. heres a link... http://www.amazon.com/American-Star-Banshee-YFZ450-Rebuild/dp/B0052UGBAQ Quote Link to comment Share on other sites More sharing options...
JKJK Posted June 12, 2015 Report Share Posted June 12, 2015 My mistake.The steel sleeve id is 10mm +The od is 15mm. Quote Link to comment Share on other sites More sharing options...
4mil89 Posted June 15, 2015 Author Report Share Posted June 15, 2015 i assum the i/d of the bushing is 15mm as well? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.