RKJLOW Posted March 9, 2015 Report Share Posted March 9, 2015 trying to synch my carbs up I can get it synced up with the fast tool but the slides are pulling uneven by sight.... so i adjust them with out the tool (dead nuts pulling up at the same time) the synch tool reads diffrent from each carb what's going on here? did a compression and leak down blows 120 each hole and held 6 psi for 30 min Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted March 9, 2015 Report Share Posted March 9, 2015 make sure carbs are pussy clean and have same size jets in both. Might have to tweak air screw. 1 Quote Link to comment Share on other sites More sharing options...
doctorwyant Posted March 10, 2015 Report Share Posted March 10, 2015 (edited) Pussy clean is a must Edited March 10, 2015 by doctorwyant Quote Link to comment Share on other sites More sharing options...
RadarRacing Posted March 10, 2015 Report Share Posted March 10, 2015 I ignore what they look like for sync and trust the airflow the tool reads. Quote Link to comment Share on other sites More sharing options...
RKJLOW Posted March 10, 2015 Author Report Share Posted March 10, 2015 im wondering if one of the carbs is fudged i had a lean runaway 2 weeksback it passed a pressure check but hmmm. they are cleaned twice now may i should try a third time.... Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted March 10, 2015 Report Share Posted March 10, 2015 Lower the idle screws till there not effecting slide height, adjust cable play so each carbs pulling up at Sam time, then go to the sync tool , don't forgot to move idle screws back up before you start. Also don't forget to leave a lol free play at the thumb Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted March 10, 2015 Report Share Posted March 10, 2015 Yahtzee^ Quote Link to comment Share on other sites More sharing options...
possum Posted March 11, 2015 Report Share Posted March 11, 2015 (edited) that will work Edited March 11, 2015 by possum Quote Link to comment Share on other sites More sharing options...
RKJLOW Posted March 12, 2015 Author Report Share Posted March 12, 2015 Lower the idle screws till there not effecting slide height, adjust cable play so each carbs pulling up at Sam time, then go to the sync tool , don't forgot to move idle screws back up before you start. Also don't forget to leave a lol free play at the thumb ill give it a go i had a helluva time adjusting the slack in the cable i have so i bought a new one... are yfz450 thumb throttles different than the banshee ones or are they a plug and play? wondering if that might be adding to the mix with my cable issue Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.