Rage_kage Posted January 24, 2015 Report Share Posted January 24, 2015 Hey guys, I'm reassembling my motor and I came across a issue adjusting the arm to the shift star, it has a lot of up and down play and I can't get full upward adjustment from the eccentric bolt. I replaced the eccentric bolt because it had wear grooves in it and tried again still not getting all the upward adjustment. Removed the shift shaft and popped the spring off and it looks like there is grooves, I don't have a new one to compare nor seen a new one . Quote Link to comment Share on other sites More sharing options...
sheerider1026 Posted January 24, 2015 Report Share Posted January 24, 2015 Get a new shift shaft. FAST sells a new oem that is already modded. Replace it or have fun fighting with it Quote Link to comment Share on other sites More sharing options...
camatv Posted January 24, 2015 Report Share Posted January 24, 2015 yup its worn. IF the end is still relativley tight you can weld that up and grind it down BUt most times when the shaft is THAT worn the end pawl is pretty shot also get a new nylon spacer, NEW spring also you should be good to go. f you get one from fast have him do his shaft modification while your there. it will help a little bit. Quote Link to comment Share on other sites More sharing options...
Rage_kage Posted January 24, 2015 Author Report Share Posted January 24, 2015 I ordered the works from fast, hell of a nice guy. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.