sleeper06 Posted June 3, 2015 Report Share Posted June 3, 2015 Alrite dude contact me by pm I've built a few Rs in my time, if your gonna throw it out let me know where u live Quote Link to comment Share on other sites More sharing options...
registered user Posted June 4, 2015 Report Share Posted June 4, 2015 You can Look up the thermal expansion of any material and that will explain why the oven works even though your heating bearing and case. With the amount of interference honda designed in the bores, its around 250ish where the interference is canceled out and becomes near zero. In lamens terms, the bearing bore and bearing are nearly the same diameter and thus allowing the bearing to be removed easily Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted June 4, 2015 Report Share Posted June 4, 2015 In all fairness, RU is right on the oven thing.Even a blind squirrel finds a nuts Quote Link to comment Share on other sites More sharing options...
registered user Posted June 4, 2015 Report Share Posted June 4, 2015 Its pretty sad when the best advice you get is someone calling you a retard. Sorry justintoxicated ill have to opologize for these guys. When they dont know the answer to a question (which is most of the time) its easier for them to act like a fool and call you names like alittle kid. This bearing and case stuff is the bare basics. You would think these guys would understand it but I guess not. Pretty clear who the retards are. But if you ask them I guess its me and you are retards lol. Hek theres even a so called engine builder chimed in that offers nothing about how to get the bearing out. For sure im gonna back to the blaster site haha Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted June 4, 2015 Report Share Posted June 4, 2015 Bye. Quote Link to comment Share on other sites More sharing options...
Bennett131 Posted June 4, 2015 Report Share Posted June 4, 2015 The engine builder offered to do it for him...and his offer was ignored. So if he ruins his cases I don't think anyone will care at this point, hell he may have even sabotaged his self for all we know. Quote Link to comment Share on other sites More sharing options...
Stevenhaines02 Posted June 6, 2015 Report Share Posted June 6, 2015 I had a few philips screws strip to hell trying to remove them with an impact driver... The screws were already trashed so i got a sharpened flat punch against the circumfrence of the screw and whacked it with a hammer. Angle the punch so when you tap on it its being pushed counter clockwise.... Got all stripped screws to break free like this. although i did have to replace them.... If you go that route just be carefull as to not gouge your cases. As for getting the bearings out, i would find a way to fix a slide hammer and heat surrounding case before trying to pull it.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.