willelvs Posted August 3, 2014 Report Share Posted August 3, 2014 (edited) Hey guys new to the forums, but I just recently purchased Vito's hemi head 4 and it's a really tight fit over the studs, like I might have to use a rubber mallet to coax it tight fit. It says it fits stock studs which is what I have in my jugs. Is this normal or should I take a slighty bigger drill bit and enlarge the few holes that aren't cooperating? Edited August 3, 2014 by willelvs Quote Link to comment Share on other sites More sharing options...
toytech Posted August 3, 2014 Report Share Posted August 3, 2014 do not drill it. check the studs for 1 thats bent. clean the studs good. use some silicone grease on the studs. Quote Link to comment Share on other sites More sharing options...
willelvs Posted August 4, 2014 Author Report Share Posted August 4, 2014 I managed to get it on and assembled, Thanks!! Quote Link to comment Share on other sites More sharing options...
SAVAGE420 Posted August 4, 2014 Report Share Posted August 4, 2014 What was the problem? Quote Link to comment Share on other sites More sharing options...
03DMshee Posted August 4, 2014 Report Share Posted August 4, 2014 What was the problem? Prolly drilled it 1 Quote Link to comment Share on other sites More sharing options...
willelvs Posted August 5, 2014 Author Report Share Posted August 5, 2014 Prolly drilled it Nope that was only gonna be my last resort. I just managed to work the head over the studs and all is well. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.