MFwray Posted July 29, 2014 Report Share Posted July 29, 2014 The guide that the slider rides on inside the carb came out, so that made the slider spin and caused it to not go down all of the way.. I put it back in and it goes too far in and it hits/stops the slider.. Has anyone had that problem and is it repairable?? I can't post any pics because it says they are too big.. Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted July 29, 2014 Report Share Posted July 29, 2014 Where did that nub go? Throuh the engine? Or does it go from outside in? I forget. Used set just came up cheep. Quote Link to comment Share on other sites More sharing options...
MFwray Posted July 29, 2014 Author Report Share Posted July 29, 2014 I have the nub/guide, I was thinking if JB weld would hold it in. If not, looks like I'm getting new carbs Quote Link to comment Share on other sites More sharing options...
Bennett131 Posted July 29, 2014 Report Share Posted July 29, 2014 I have a cheap set of stockers if you cant fix it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.