Nash Jesso Posted July 29, 2014 Report Share Posted July 29, 2014 When my shee is running i have to kill it with the key,kill switch is hooked up but doesn't work.my lights dont work either bulbs seem fine,i think it may be related to the problem with the kill switch. Any ideas on how to fix this? Quote Link to comment Share on other sites More sharing options...
Starwriter Posted July 29, 2014 Report Share Posted July 29, 2014 The only way they could be related is if the handle bar switch connector is unplugged. The most likely thing on the kill switch is that the plastic board piece inside the housing has popped out of place and the sliding switch contact is not touching it or a wire is broke off at the solder connection on the board. Common problems. Cut and resolder the wires. I haven't taken the time to figure out a solution for the board slipping out of place, but probably best to use epoxy or a screw to hold that piece in the slot. As for the lights, you're going to have to track that down yourself with a multimeter. Quote Link to comment Share on other sites More sharing options...
Nash Jesso Posted July 29, 2014 Author Report Share Posted July 29, 2014 Thanks ill pull it apart tomorrow and see,as for lights ill try different bulbs and make sure there aren't any damaged wires Quote Link to comment Share on other sites More sharing options...
Starwriter Posted July 29, 2014 Report Share Posted July 29, 2014 Use a multimeter. Check for voltage at the voltage regulator. Check for voltage at the power wire to the headlight switch. If you have no voltage anywhere, use the ohm setting to check the stator windings. If you just plug new bulbs in and the voltage regulator is bad or unplugged, you'll just blow the new bulbs. Here's the electrical FAQ. http://bansheehq.com/forums/index.php?showtopic=133650 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.