jacowils Posted May 22, 2014 Report Share Posted May 22, 2014 I currently have a fresh top end that im going to break in tomorrow and right now i am running 320 mains, 27.5 pilots, the air screw 2 turns out and the needle on the 4th clip from the top. I want to make sure im rich enough while breaking in the top end so that once ive ran through an entire tank of gas for the break in procedure that jeff from FAST has instructed me to do i can do a plug chop to get it just right, again i just want to be on the safe side for the break in. My mods include .030 over with wisecos, fmf fattys with turbinecore silencers, boyesen power reeds, and k&n pods. Quote Link to comment Share on other sites More sharing options...
jacowils Posted May 22, 2014 Author Report Share Posted May 22, 2014 Forgot to mention I'm at 700 ft above sea level and temps right around 75 degrees, also stock carbs, thanks. Quote Link to comment Share on other sites More sharing options...
driftingbanshee Posted May 25, 2014 Report Share Posted May 25, 2014 What mods? dont talk to morons you only educate them.. Quote Link to comment Share on other sites More sharing options...
RKJLOW Posted June 3, 2014 Report Share Posted June 3, 2014 My mods include .030 over with wisecos, fmf fattys with turbinecore silencers, boyesen power reeds, and k&n pods. Quote Link to comment Share on other sites More sharing options...
driftingbanshee Posted June 4, 2014 Report Share Posted June 4, 2014 I'd say you might be a bit small on the pilot but it varies bike to bike. 320 will be close but maybe a touch on the lean side. dont talk to morons you only educate them.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.