thomas h. Posted January 18, 2014 Report Share Posted January 18, 2014 I'm going thru this new to me shee and now I notice this part is bad. When I go to replace it will I need to split cases? I'm hoping to just take The clutch basket area apart and swap it out. What should I prep for? I've never split the cases on my own. Quote Link to comment Share on other sites More sharing options...
Hazzard Racing Customs Posted January 18, 2014 Report Share Posted January 18, 2014 Pm sent Quote Link to comment Share on other sites More sharing options...
Surfrjag Posted January 18, 2014 Report Share Posted January 18, 2014 clutch arm should slide right out once you pull the actuator rod away from it through the clutch Quote Link to comment Share on other sites More sharing options...
thomas h. Posted January 18, 2014 Author Report Share Posted January 18, 2014 Thanks Quote Link to comment Share on other sites More sharing options...
J-Madd Posted January 18, 2014 Report Share Posted January 18, 2014 What's wrong with it? Its common for the part where to cable goes to get loose. Quote Link to comment Share on other sites More sharing options...
thomas h. Posted January 18, 2014 Author Report Share Posted January 18, 2014 The hole is egg shaped at the cable pull end. Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted January 18, 2014 Report Share Posted January 18, 2014 There all loose but theres a fine line, fast racing has them ive ordered new from him a few times cheap part in the grand scheme Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted January 19, 2014 Report Share Posted January 19, 2014 Be a good time to do a fresh rod, ball, and pancake bearing as well as the actuator. Quote Link to comment Share on other sites More sharing options...
thomas h. Posted January 19, 2014 Author Report Share Posted January 19, 2014 Yup Quote Link to comment Share on other sites More sharing options...
Atomic Monkey Posted January 20, 2014 Report Share Posted January 20, 2014 Fairly simple fix, but need to pull the kick side case off. I replaced all the linkage after a ball-weld. Got some pics and tips if you need Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.