mfritz23 Posted December 23, 2013 Report Share Posted December 23, 2013 my throttle cable broke and need a new one just asking u guys best one to buy was just browsing ebay figured I would get some opinions carbs are keihin 33mm thanks also looking at getting a new extended throttle lever what do u recommend last question was looking at my thumb part and noticed electrical wires run into like a little switch inside there what is that and does aftermarket extended throttles accept that piece or what thanks for the help and have a good xmas. Quote Link to comment Share on other sites More sharing options...
oldskool Posted December 23, 2013 Report Share Posted December 23, 2013 ATVgalaxy(site sponsor) Those wires are part of the tors. Most people delete anything to do with the tors. Quote Link to comment Share on other sites More sharing options...
mfritz23 Posted December 24, 2013 Author Report Share Posted December 24, 2013 ok thanks will check them out bought quad this summer has a lot of work done to it figured tors was removed already lol is it hard to delete it Quote Link to comment Share on other sites More sharing options...
mfritz23 Posted December 24, 2013 Author Report Share Posted December 24, 2013 just went and double checked my tors is removed they just left the wires in the thumb throttle part thanks oldskool Quote Link to comment Share on other sites More sharing options...
wayne_smith97 Posted December 24, 2013 Report Share Posted December 24, 2013 (edited) You can order a tors delete which generally consist of new carb caps with cable and idle screws and a drill bit and tap to tap out idle screw holes. It's not hard to do. There is a post on here somewhere with step by step directions and pictures to follow along with Disregard this post then lol Edited December 24, 2013 by wayne_smith97 Quote Link to comment Share on other sites More sharing options...
Starwriter Posted December 24, 2013 Report Share Posted December 24, 2013 Take the switch out of the thumb throttle. Chop the wires. Slide the rubber grommet off the wires. Put some black silicone in the hole in the grommet and put the grommet back in the thumb throttle. Or, if you're into bling, Cascade makes a very nice billet piece to replace the grommet for $20. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.