charlie__walsh Posted September 27, 2013 Report Share Posted September 27, 2013 So I bought a 04 banshee there was a reving problem it would just run veryhigh, what happened was the owner put a tors eliminator kit on, the air acrew was out 3.5 turns and I fixed that to 2 turns, he switched the sliders (have them fixed), idle screws were not touching(filled down and now It hits slider), cleaned out carb. So now I have all mycarbs back in and she runs first kick...great! So I was running it and noticed the oil spitting out the tailpipe on to the floor.... I don't no were to go from here... I think its my slider adjusters on the top of the carb! ??????????????????????????????????? Quote Link to comment Share on other sites More sharing options...
Starwriter Posted September 27, 2013 Report Share Posted September 27, 2013 (edited) I would bet it was running slobbery rich when the slides were in the wrong sides and there's a bunch of premix oil sitting in the pipes. The carbs do need to be synced, but I bet if you pull the pipes, oil will pour out of them. Edited September 27, 2013 by Starwriter Quote Link to comment Share on other sites More sharing options...
charlie__walsh Posted September 27, 2013 Author Report Share Posted September 27, 2013 so it should be fine? because it runs way better its just the oil I am worried about.! Quote Link to comment Share on other sites More sharing options...
charlie__walsh Posted September 27, 2013 Author Report Share Posted September 27, 2013 Will do but I'm wondering to... Do I have my sliders adjusted properly... I have them sinced there even at no throttle half throttle and full ... But I pull in my choke and it dies I'm thinkin i have my settings wrong... Quote Link to comment Share on other sites More sharing options...
charlie__walsh Posted September 27, 2013 Author Report Share Posted September 27, 2013 And I changed my clip to the 3rd from the bottom... Quote Link to comment Share on other sites More sharing options...
charlie__walsh Posted September 27, 2013 Author Report Share Posted September 27, 2013 It's completely stock.. I figured sence he was messing with everything he changed clip position... So I looked up online an it said third from the bottom... Quote Link to comment Share on other sites More sharing options...
oldskool Posted September 27, 2013 Report Share Posted September 27, 2013 You gonna need to see what size them jets are! You got air screw at 3.5 turns out? I would suggest a good, very good carb cleaning. This means take carbs completely apart spraying cleaner in every hole or even better soak, then clean with compressed air. Just saying, make sure air filter is clean. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.