LowlyOilBurner Posted September 24, 2013 Report Share Posted September 24, 2013 I bought these a few weeks ago hoping to use them on a 10DM. I spoke with a couple builders, and as it turns out, they will require WAY to much work to make that happen. Specs: -102mm spread -Small bearing (62mm) -Deck height is stock, I believe. If someone with more knowledge knows otherwise, let me know. -Trenched for 18mm -Top case has been setup for Twister cylinders, and expoxy has been used, as seen in the photos. -Stator side of top case also has epoxy near the top where the cylinders sit in the case (see photo) -MOST of the hardware is included which hold the two halves together from the underside of the case, cylinder side. -Hardware IS needed for the transmission side. These could be a deal for someone, they could be made to work with other cylinders, but a FUCK of alot of welding would have to be done. I was going to remove the epoxy and weld them back up myself, but the post machining time would be a killer, at that point I might as well buy new cases. Price: $925.00, shipped. Pics: Price: $925.00 shipped Quote Link to comment Share on other sites More sharing options...
Gotmils? Posted September 24, 2013 Report Share Posted September 24, 2013 Pm sent Quote Link to comment Share on other sites More sharing options...
LowlyOilBurner Posted September 24, 2013 Author Report Share Posted September 24, 2013 Pm replied. Quote Link to comment Share on other sites More sharing options...
LowlyOilBurner Posted September 30, 2013 Author Report Share Posted September 30, 2013 Ttt. Quote Link to comment Share on other sites More sharing options...
LowlyOilBurner Posted October 2, 2013 Author Report Share Posted October 2, 2013 Open to reasonable offers. Quote Link to comment Share on other sites More sharing options...
LowlyOilBurner Posted October 7, 2013 Author Report Share Posted October 7, 2013 Bump. Offers... Quote Link to comment Share on other sites More sharing options...
LowlyOilBurner Posted October 10, 2013 Author Report Share Posted October 10, 2013 Sold. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.