salmon_slayer06 Posted September 20, 2013 Report Share Posted September 20, 2013 (edited) The vent was clear on mine, but the seal popped out anyways. I had too much oil in it. I found that the sealant I used caused the seal to slide out. Like some have said.... use no sealant. I wish these were grooved seals. Edited September 20, 2013 by salmon_slayer06 Quote Link to comment Share on other sites More sharing options...
Jereme6655 Posted September 21, 2013 Report Share Posted September 21, 2013 woffy.....like said....try a new seal, with an extremely clean surface. And also watch the amount of fluid you put in the trans. Where are you from in Michigan? I ride quite often in Mio. Quote Link to comment Share on other sites More sharing options...
Coupelx Posted September 21, 2013 Report Share Posted September 21, 2013 Whats too much oil? I run 2 qts and never popped a seal. Quote Link to comment Share on other sites More sharing options...
woofy Posted September 23, 2013 Author Report Share Posted September 23, 2013 woffy.....like said....try a new seal, with an extremely clean surface. And also watch the amount of fluid you put in the trans. Where are you from in Michigan? I ride quite often in Mio. Quote Link to comment Share on other sites More sharing options...
woofy Posted September 23, 2013 Author Report Share Posted September 23, 2013 I was jus in mio a wk ago. That's wen my seal popped out. Quote Link to comment Share on other sites More sharing options...
salmon_slayer06 Posted September 24, 2013 Report Share Posted September 24, 2013 You guys may want to check out St. Helen. They groom the trails. Its actually the main ORV trail that I ride, goes from Roscommon to southeast end of Houghton Lake. Gotta stash gas cans if you want to do the entire route. Its a rush, beats silver lake any day IMO. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.