sstaton1983 Posted July 20, 2013 Report Share Posted July 20, 2013 I just recently traded for a 421 cub that has a 13 tooth sprocket.when I tried putting on a 14 from my other banshee the center hole was to small. The splines look the same just bigger then my other banshee's. I thought the output shaft sizes were all the same? Quote Link to comment Share on other sites More sharing options...
sstaton1983 Posted July 21, 2013 Author Report Share Posted July 21, 2013 Anyone have any input? Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted July 21, 2013 Report Share Posted July 21, 2013 Maybe a rz trans? Quote Link to comment Share on other sites More sharing options...
sstaton1983 Posted July 22, 2013 Author Report Share Posted July 22, 2013 I thought that too, but every rz front sprocket iv seen has splines that look like axle splines. Quote Link to comment Share on other sites More sharing options...
sstaton1983 Posted July 22, 2013 Author Report Share Posted July 22, 2013 (edited) this is from a 84 rz 350.maybe im wrong. those splines look the same as a banshee. Edited July 22, 2013 by sstaton1983 Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted July 23, 2013 Report Share Posted July 23, 2013 The Yamaha parts fiche I used showed the 84 RZ350 shared the same part numbers for the shaft, washer and nut as the Banshee. Post some pics Quote Link to comment Share on other sites More sharing options...
sstaton1983 Posted July 23, 2013 Author Report Share Posted July 23, 2013 I'll pull the sprocket back off tomorrow post pics and get the p/n off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.