Vinny_Vincenzo408 Posted May 21, 2013 Report Share Posted May 21, 2013 What are the torque specs for the cyclinders Quote Link to comment Share on other sites More sharing options...
rg97 Posted May 21, 2013 Report Share Posted May 21, 2013 Manual says 28 nM/ 20 ft. lbs for the head bolts AND the nuts thatgo on the jug itself to connect to the crankcase 1 Quote Link to comment Share on other sites More sharing options...
Vinny_Vincenzo408 Posted May 21, 2013 Author Report Share Posted May 21, 2013 Thanks Quote Link to comment Share on other sites More sharing options...
SAVAGE420 Posted May 21, 2013 Report Share Posted May 21, 2013 .....as said above, but go in sequence, hand tight,then 10 then 15 then 22....is what i do. The sequence is on the stock head 1 thru 10 Quote Link to comment Share on other sites More sharing options...
Pastrykiller Posted May 21, 2013 Report Share Posted May 21, 2013 Turn it till it cracks then back off 1/2 turn. Should be 20 ftlbs Quote Link to comment Share on other sites More sharing options...
Jereme6655 Posted May 21, 2013 Report Share Posted May 21, 2013 like savage says... Quote Link to comment Share on other sites More sharing options...
BigRed350x Posted May 21, 2013 Report Share Posted May 21, 2013 Just wing it. Tighten them down until they strip out, then go backwards a half turn & your good to go. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.