375hp banshees Posted May 7, 2013 Report Share Posted May 7, 2013 is anybody running (34mm) lectrons on there dune ported stock cylinder shee ? w/ w/o power jets what needles I've got 34's w/ 3-1 needle & i'm at at sea level Quote Link to comment Share on other sites More sharing options...
Nieskes Posted May 7, 2013 Report Share Posted May 7, 2013 What fuel? Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted May 8, 2013 Author Report Share Posted May 8, 2013 What fuel? pump gas 4 now Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted May 8, 2013 Author Report Share Posted May 8, 2013 34mm high velocity Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted May 11, 2013 Author Report Share Posted May 11, 2013 bump!! Quote Link to comment Share on other sites More sharing options...
trickedcarbine Posted May 16, 2013 Report Share Posted May 16, 2013 Pm Camatv Quote Link to comment Share on other sites More sharing options...
rubberneck Posted May 16, 2013 Report Share Posted May 16, 2013 i have 34 lectrons with PJs running sea level on a 4mil dune port motor. They are not HV I got them straight from packard and he put 5-2xl needles in them. I only ran them for 1 trip and they were pretty close but maybe needed a 5-3 needle. I had to run the needle out a bit to get the idle cleaned up then it seemed to be a little lean in the middle right before the PJs came on. I was going to order some to try however am making changes to the motor, so i will go with what i have and start the tuning process over and see where i land. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.