BeeCanBanshee Posted April 22, 2013 Report Share Posted April 22, 2013 Ok so I have lrd adjustable pipes, +5 timing, vf2's, cool head 20cc domes, mild port, stock carbs tors delete with uni pods. Switching to a airbox with k&n's soon. Elevation is 88ft above sea. 65 degrees had 25 pilots and 300 mains. It idled fine but would hang when gas was tapped. So I switched to a 27.5 and the hanging stoped but it won't idle. At the moment idle screws are all the way in and mixture screws 2 turns out. Carbs are clean and synced. Any ideas. Quote Link to comment Share on other sites More sharing options...
BeeCanBanshee Posted April 22, 2013 Author Report Share Posted April 22, 2013 Sorry the air box is the no top aluminum one CFM performance with k&n filters. Quote Link to comment Share on other sites More sharing options...
noonansar Posted April 24, 2013 Report Share Posted April 24, 2013 Try adjusting the air (mixture) screw in half turn increments. Mine seems to idle good around 1 1/2 turns out , but every bike is different. Have you changed plugs lately? Fouled plugs can effect idle too. Quote Link to comment Share on other sites More sharing options...
BeeCanBanshee Posted April 24, 2013 Author Report Share Posted April 24, 2013 I'm changing plugs today and I turned them in to 1.5 turns. Quote Link to comment Share on other sites More sharing options...
toytech Posted April 24, 2013 Report Share Posted April 24, 2013 did you grind enough off the carbs for the idle screws to raise the slides enough? also make sure the choke tube is tight on the carbs. Quote Link to comment Share on other sites More sharing options...
BeeCanBanshee Posted April 24, 2013 Author Report Share Posted April 24, 2013 Choke tube is just on with no clamps. That's how I got em. And I didn't install the tors delete. But was thinking that might be the problem. Quote Link to comment Share on other sites More sharing options...
oldskool Posted April 24, 2013 Report Share Posted April 24, 2013 did you grind enough off the carbs for the idle screws to raise the slides enough? also make sure the choke tube is tight on the carbs. x2 look in your carbs and see if the idle screw moves the slide when you adjust it. If the slides don't move when the screw is turned in all the way you need to take some more off the carb body(outside) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.