Anthony133 Posted February 28, 2013 Report Share Posted February 28, 2013 I have 2000 banshee cylinders which HJR bored and honed to 66mm, and DRAG ported. They are in perfect condition, i change my engine plans and these wont work. Porting and boring cost me $510 alone.................$600 shipped to anywhere in the US. PM me or send money to anthonyabbate@att.net (paypal) They CAN ship tomorrow!!!! Quote Link to comment Share on other sites More sharing options...
chere Posted February 28, 2013 Report Share Posted February 28, 2013 Priced to sell fast huh Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted February 28, 2013 Report Share Posted February 28, 2013 Quote Link to comment Share on other sites More sharing options...
Anthony133 Posted March 1, 2013 Author Report Share Posted March 1, 2013 Basically im just getting my money back for the port and bore work... between buying cylinders then having the work done, this is alot cheaper. Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted March 1, 2013 Report Share Posted March 1, 2013 Pistons or anything else with it? Quote Link to comment Share on other sites More sharing options...
tsharktim Posted March 1, 2013 Report Share Posted March 1, 2013 Might have to bite the bullet on this one.... Quote Link to comment Share on other sites More sharing options...
Finch Posted March 1, 2013 Report Share Posted March 1, 2013 Pistons or anything else with it? ky jelly? Quote Link to comment Share on other sites More sharing options...
Anthony133 Posted March 3, 2013 Author Report Share Posted March 3, 2013 Just the jugs, i can even throw in the stock head thats been refurbished and matches the jugs Quote Link to comment Share on other sites More sharing options...
Anthony133 Posted March 3, 2013 Author Report Share Posted March 3, 2013 500 is the lowest ill go Quote Link to comment Share on other sites More sharing options...
Anthony133 Posted March 3, 2013 Author Report Share Posted March 3, 2013 any lower and i could just find cheap parts, build an engine and put it on my lawnmower or something LOL Quote Link to comment Share on other sites More sharing options...
chere Posted March 3, 2013 Report Share Posted March 3, 2013 Especially stockers at the end of the line. .. Quote Link to comment Share on other sites More sharing options...
springer Posted March 3, 2013 Report Share Posted March 3, 2013 not to mess up your thread, but those don't look like a "drag port" to me. i had a set of hjr drag jugs and they look nothing like that. 1 Quote Link to comment Share on other sites More sharing options...
sprinklerman Posted March 3, 2013 Report Share Posted March 3, 2013 Especially stockers at the end of the line. .. I don't think id call those cyls " end of the line"... How often do you actually have to bore a cyl?? Once every 2-3 seasons ? If everything goes right (you dont run each bore too long ,etc) that SHOULD leave you 2 bores (MAX) left. so you should see 4+ seasons out of these cyls, if they are round now, with "normal/consistent " wear. they are on the last end of the bores left, but i wouldnt make it seem like they are all used up. If you take care of them,you should get a good amount of use. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.