banlee Posted October 31, 2012 Report Share Posted October 31, 2012 ok so this is my first engine tear down. and i was putting the top bolts back on and it breaks. and so did the next one... and i wasn't even close to as tight as they need to be. so much so that when the cases were split again i could unscrew the broken part with my fingers... what the hell is going on? i think i put to much liquid gasket on if that has anything to do with it... what is the best way to put that stuff on? Quote Link to comment Share on other sites More sharing options...
Starwriter Posted October 31, 2012 Report Share Posted October 31, 2012 Maybe you need a new torque wrench. Quote Link to comment Share on other sites More sharing options...
vulvafan537240 Posted October 31, 2012 Report Share Posted October 31, 2012 Eat less spinach Quote Link to comment Share on other sites More sharing options...
banlee Posted October 31, 2012 Author Report Share Posted October 31, 2012 But like I said bolth pieces of the bolt came out by spinning with my fingers... Quote Link to comment Share on other sites More sharing options...
banlee Posted October 31, 2012 Author Report Share Posted October 31, 2012 And they really were not tight at all.. Quote Link to comment Share on other sites More sharing options...
Dicklez Posted October 31, 2012 Report Share Posted October 31, 2012 Maybe you dropped to much acid before you started your rebuild. Quote Link to comment Share on other sites More sharing options...
gappa38 Posted October 31, 2012 Report Share Posted October 31, 2012 well after the bolt breaks in half both pieces will be loose again because the tension is gone, but it only takes a thin bead of sealer maybe 1/8 in wide, thats what i used and still squeezed out of the sides Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.