The-Association Posted October 18, 2012 Report Share Posted October 18, 2012 After changing oil i went out riding for a day.. On the way out my shee stuck in 3rd and 4th. So i took the clutches and jaz off. So now i lookin at shift star.. When shifting up and down the arm moves good.. But seems that shift star will not completely rotate.. Is thisbent forks or the spring behind star? Quote Link to comment Share on other sites More sharing options...
The-Association Posted October 18, 2012 Author Report Share Posted October 18, 2012 Plz help on topic stuck in 3rd and 4th gear plz Quote Link to comment Share on other sites More sharing options...
cameronchaos Posted October 18, 2012 Report Share Posted October 18, 2012 Plz help on topic stuck in 3rd and 4th gear plz This happened to me one time I pulled the clutch cover off and the shift shaft had Messed up it was a really easy fix hopefully that's what is going on with yours too Quote Link to comment Share on other sites More sharing options...
bluebanshee98 Posted October 18, 2012 Report Share Posted October 18, 2012 prob the shift forks or shift shaft. if you dont have the shift star mod done i would do it while your down there Quote Link to comment Share on other sites More sharing options...
The-Association Posted October 18, 2012 Author Report Share Posted October 18, 2012 prob the shift forks or shift shaft. if you dont have the shift star mod done i would do it while your down there How do i tell if its either.. I notices it clickez threw 2 gears kinda fine and get stuck on rest.. Should the shift star move freely by hand? Quote Link to comment Share on other sites More sharing options...
The-Association Posted October 18, 2012 Author Report Share Posted October 18, 2012 This happened to me one time I pulled the clutch cover off and the shift shaft had Messed up it was a really easy fix hopefully that's what is going on with yours too And how was ur shift shaflft messed up.. Im a newb on shess so far on bottem end Quote Link to comment Share on other sites More sharing options...
Jereme6655 Posted October 18, 2012 Report Share Posted October 18, 2012 Ok....first grammar.....clickez is not a word and terrible grammar will get you no where with good help on bhq. The banshee trans will not like to shift while just sitting there and not spinning. Try rotating the clutch assembly while you shift it through a few gears. Also make sure your eccentric screw is adjusted accordingly. If your unsure about most of this stuff, a clymers manual will help you immensely. Quote Link to comment Share on other sites More sharing options...
AKheathen Posted October 18, 2012 Report Share Posted October 18, 2012 no, you should need pliers to turn it. put the roller back on the star and make sure the claws are centered proeprly. may need a washer on the end of the shift-shaft, or pull the case gasket and use blue silicone sealant. to tighten up the shaft play. check that the drum is not able to move in/out. you will need to rotate the gears while shifting to make them line up. Quote Link to comment Share on other sites More sharing options...
The-Association Posted October 18, 2012 Author Report Share Posted October 18, 2012 no, you should need pliers to turn it. put the roller back on the star and make sure the claws are centered proeprly. may need a washer on the end of the shift-shaft, or pull the case gasket and use blue silicone sealant. to tighten up the shaft play. check that the drum is not able to move in/out. you will need to rotate the gears while shifting to make them line up. It seems like the shift star is jamed up..think its a fork then? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.