Bansheeb0y5505 Posted July 10, 2012 Report Posted July 10, 2012 To this day I can get my banshee running decent but never perfect, always has some kind of hiccup. My mods include FMF Fatty's, Powercore II silencers, +4 timing plate, airbox lid removed with a K&N filter, Boysen RAD valves, and that's it. My current jetting is 270 mains, 27.5 pilots, needle clip in stock position. When it's cold, it pulls strong and doesn't hesitate or stutter. But when it's up to full operating temperature, it has no low end. It runs like shit until I get into the rev's then it pulls hard. I also foul out plugs every ride or two. I sync'd the carbs and messed with the air/fuel screws... My father has an identical setup but with a stock airbox lid still on and stock reeds. He has 260's and stock pilots and his runs PERFECT. One of the best running banshee's I have ridden. He took his lid off one day to fuck around and it popped a little from being too lean. So I figured it makes sense to go 10 up on the main jet for mine since I run open airbox (hence the 270) and I put the 27.5's in because FMF recommended it and it did help over the stock pilots. I'm at a loss here. Are the weird shape of the RAD valve reed cages messing me up? I don't know where to start at this point. Quote
Bansheeb0y5505 Posted July 10, 2012 Author Report Posted July 10, 2012 By the way I checked the impellar and it's in good shape, the whole coolant system is functioning properly and none of my friends or fathers banshee's have overheating issues with the riding we do so I don't believe it's related. Quote
Glamis321 Posted July 10, 2012 Report Posted July 10, 2012 If your fouling plugs your jetting is too rich or your using a lot of oil in your fuel mixture. Sounds like you need to play with the jetting. What elevation are you riding at? Quote
Bansheeb0y5505 Posted July 10, 2012 Author Report Posted July 10, 2012 Not sure what the elevation is, it's out here in the coal region so probably higher up. But everyone I ride with that have banshee's ride in the same spots and don't have issues with their jetting. That's the troublesome part.. Quote
CarvedArt Posted July 10, 2012 Report Posted July 10, 2012 Not sure what the elevation is, it's out here in the coal region so probably higher up. But everyone I ride with that have banshee's ride in the same spots and don't have issues with their jetting. That's the troublesome part.. If your plugs are wet fouling then you're rich... Those reeds are going to richen up your mid-range you may need to go leaner on your needles (move the clip up 1) If you go to 260s does yours pop? Go here and find your elevation: www.earthtools.org Then adjust accordingly: about +1 on the mains for every 1500' higher and -1 for every 1500' lower Also as the temperature goes up it gets richer (air gets thinner as it's heated) Ambient temperatures above 90 deg F = -1 on the mains Ambient temperatures below 60 deg F = +1 on the mains or you could put your airbox lid back on when the temp drops Don't know what your premix ratio is: 20:1 = up to +2 on the mains 24:1 = up to +2 on the mains 32:1 = 0 on the mains 40:1 = up to -2 on the mains 50:1 = up to -2 on the mains Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.