bansheecaptain Posted May 28, 2012 Report Share Posted May 28, 2012 so i split the cases and did upgrades and after i put everything back together i did a leak down test 6 for 6 and it passed . sync carbs with sync tool and dead on . now the left side even after i shot off the engine and pull a carb off or pull out a plug there is white well what seems to be white smoke omes out of cyl. and ive put on the noss head prolly about 6 times to stop that one side from leaking thinking its the head and i put new rings in and use white grease with the o-rings . any idea what it is should i split the cases again . doesnt seem to be looseing tranny oil and i put new seals and crank bearings in . any ideas would help thanks Quote Link to comment Share on other sites More sharing options...
coryv4 Posted May 29, 2012 Report Share Posted May 29, 2012 how do you know your right side isn't just running too good? Quote Link to comment Share on other sites More sharing options...
bansheecaptain Posted May 29, 2012 Author Report Share Posted May 29, 2012 smokes alot out that side and it doesnt make any power wont rev up it just bogs right out Quote Link to comment Share on other sites More sharing options...
erickson483 Posted May 29, 2012 Report Share Posted May 29, 2012 Check your reedsand clean the your carbs really good. I had a similar problem and it ended up being a tiny piece of dirt in where the needle seats in the carb. Quote Link to comment Share on other sites More sharing options...
bansheecaptain Posted May 29, 2012 Author Report Share Posted May 29, 2012 Not the carbs they are super clean and I switched carb and plug leads and the problem didn't follow carb or plugs. I took reeds out I have V-force 2 reeds and there is no gaps in the peddleds but a couple you can see alittle light threw the peddle but not at the tips. Quote Link to comment Share on other sites More sharing options...
zach45 Posted May 29, 2012 Report Share Posted May 29, 2012 Have you done a compression test? Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
bansheecaptain Posted May 30, 2012 Author Report Share Posted May 30, 2012 140psi runnng 20cc domes and 1300 above sea level Quote Link to comment Share on other sites More sharing options...
coryv4 Posted May 30, 2012 Report Share Posted May 30, 2012 stator or cdi might be going bad. Quote Link to comment Share on other sites More sharing options...
bansheecaptain Posted May 30, 2012 Author Report Share Posted May 30, 2012 how will the effect the same side even after switching plug leads and its stil the same side Quote Link to comment Share on other sites More sharing options...
thomas h. Posted May 30, 2012 Report Share Posted May 30, 2012 Floats levels gave me that problem Quote Link to comment Share on other sites More sharing options...
bansheecaptain Posted May 30, 2012 Author Report Share Posted May 30, 2012 Both carbs are set at 19mm. They are 28's. And like I said I switchem siide to side to see if it was the carbs and still left side wouldn't rev up Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.