Jump to content

Where Does One Find A 30mm hex drive For Steering Bearing Removal?


bansh_88

Recommended Posts

what ive always used is very handy and im sure everyone on this site has it. Take your flywheel puller and take the center bolt out of it. now flip it upside down and set it down into the steering stem bearing retainer, now from the bottom thread your bolt back into the puller until it bottoms out then it will turn that retainer right out. No welding, no homemade tool.

 

Ive had both motion pro and now OTC flywheel puller and they both were the correct size.

Sounds to easy I'm trying this tonight

 

 

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

Snap On sells them.  They're high, but that's what we have at the shop.  I'd recommend not doing the Snap On route and going with what everyone else has posted.  Craftsman Pro Series used to have them IIRC.

Link to comment
Share on other sites

asy7y7yd.jpg

Just weld up your own junk and get it done like I did.

Works Decent!

 

Sent from my shed.

Link to comment
Share on other sites

^stick to welding shopping carts

I do. 13 bux a pop to the other shopping mall.

Don't touch the handle.

 

Sent from my shed.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...