thomas h. Posted December 24, 2011 Report Share Posted December 24, 2011 So with the long needle in leanest clip the one (with 6 clips maybe call a dyno jet needle from alba no markings )the power was flat then mid to top pulls good. With the stock needle mid clip it goes then dies abit then pulls good. I think it needes more fuel Stock carbs 310 m 27.5 stock needles Toomey t4 k&n no port. Clean carbs ok plugs Quote Link to comment Share on other sites More sharing options...
hp2000 Posted December 24, 2011 Report Share Posted December 24, 2011 Mine kinda did the same before. Have you tried stock needle, clip second notch top to bottom? Quote Link to comment Share on other sites More sharing options...
sleeper06 Posted December 25, 2011 Report Share Posted December 25, 2011 So with the long needle in leanest clip the one (with 6 clips maybe call a dyno jet needle from alba no markings )the power was flat then mid to top pulls good. With the stock needle mid clip it goes then dies abit then pulls good. I think it needes more fuel Stock carbs 310 m 27.5 stock needles Toomey t4 k&n no port. Clean carbs ok plugs why would you try the leanest setting,longer needles sit in the jet more so try 4th clip,how does the plug look Quote Link to comment Share on other sites More sharing options...
thomas h. Posted December 25, 2011 Author Report Share Posted December 25, 2011 Good catch sleeper. I got it wrong I'll put it back it and try it Do you like the longer ones? Thanks for all you help this past year! Ps are you going to glamis with wacko 2000 in feb ? Quote Link to comment Share on other sites More sharing options...
thomas h. Posted December 27, 2011 Author Report Share Posted December 27, 2011 Back to long needle on the max rich clip. So it goes.. Then bogs ... Then pulls hard.... This is with the air screw .5 out. I might try the stock needle max rich clip but it seem to want the pilot bigger? Also does the air idle mix screw close out air or fuel? Quote Link to comment Share on other sites More sharing options...
thomas h. Posted December 28, 2011 Author Report Share Posted December 28, 2011 Ok now just tryed the short stock needle on Max rich clip And it seemed to load up then go hard. Next gear alittle less. But you go slow first gear and it seemed to load up like to much fuel. The best so far might be long needle and 2 nd to rich. Do most banshees have a lag at the bottom I still want to get ride of the bog between low to mid Any in put? Quote Link to comment Share on other sites More sharing options...
jaspersbanshee Posted December 28, 2011 Report Share Posted December 28, 2011 I run stock needles clipped 2nd from top. No port work just polished. k&n filter with no lid. most banshees have some low rpm lag. to help that, put in some reed spacers between reeds and cylinder. also i advance the timing 4 degrees. it helped me alot. Good luck!!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.