Jump to content

01 banshee partout Aftermarket and stock


Recommended Posts

  • Replies 72
  • Created
  • Last Reply

Top Posters In This Topic

Lsr +4 Swingarm, pc silvervein some of the powdercoat is chipped off. Its solid no cracks or repairs. Comes with longer chain. $225

Full Toomey T5 exhaust system (pipes and silencers) Good overall shape normal chrome wear up near cylinders. 225

Chrome steering stem stock height. $60

Complete bottom end, Good stock crank and tranny, also Comes with flywheel and good stator with both covers. No leaks. Cases are good they have a very small little chip missing from the chain hitting. $300

Cylinders 64.5mm Good bore/crosshatch ( only .5mm over stock Means lots of bores left in them) $225

Complete clutch , basket plates everything $50

Stock radiator $10

Thumb Throttle assembly (tors plug cut off) $10

Intake boots with crossover tube $10

Chrome spindles with front wheel hubs and rotors Good bearings. $50

Rear wheel hubs $40

Brake hub and rotor rear, rotor shows some wear but still useable $10

Axle carrier Good bearings $50

Orange tank cover and grill plastic $30

Black maier front fenders factory race cuts, and black radiator/grill plastic $40

Rear plastic (painted black) $20

Front plastic cut (painted black) $20

Red front plastic with tank cover and grill/radiator plastic $40

Blue tank cover $10 (cpl stress marks)

Stock seat needs recovered $10\

Kickstart lever and knuckle assembly $20

HEadlight/ run switch works good small peice of Hi/Lo headlight switch broke off still enough there to use $10

Misc hardware/parts lot Shifter, Pipe hangers, chain adjusters, steering stem clamp/bushing, headlight mounts, engine mounts... all for $20

Edited by f4istunna
Link to comment
Share on other sites

spindles/hubs just sold yesterday sorry

carrier sold also

 

heres whats left

 

+4 Swingarm, pc silvervein some of the powdercoat is chipped off. Its solid no cracks or repairs. Comes with longer chain. $150

Chrome steering stem stock height. $60

Complete bottom end, Good stock crank and tranny, also Comes with flywheel and good stator with both covers. No leaks. Cases are good they have a very small little chip missing from the chain hitting, outer crank bearings will need replaced. $200

Cylinders 64.5mm Good bore/crosshatch ( only .5mm over stock Means lots of bores left in them) $225

Complete oemclutch , basket plates everything very nice shape $50

Thumb Throttle assembly (tors plug cut off) $10

Rear wheel hubs $40

Brake hub and rotor rear, rotor shows some wear but still useable $10

Orange tank cover and grill plastic $30

Black maier front fenders factory race cuts, and black radiator/grill plastic $40

Rear plastic (painted black) $20

Front plastic cut (painted black) $20

Red front plastic with tank cover and grill/radiator plastic $40

Blue tank cover $10 (cpl stress marks)

Stock seat needs recovered $10\

Kickstart lever and knuckle assembly $20

HEadlight/ run switch works good small peice of Hi/Lo headlight switch broke off still enough there to use $10

Misc hardware/parts lot Pipe hangers, chain adjusters, steering stem clamp/bushing, headlight mounts, engine mounts... all for $20

Link to comment
Share on other sites

never had headlights sorry

 

Cylinders are sold now aswelll.

 

Ill take offers on the rest looking to clear some room in the garage

 

 

Chrome steering stem stock height. $60

Complete bottom end, Good stock crank and tranny, also Comes with flywheel and good stator with both covers. No leaks. Cases are good they have a very small little chip missing from the chain hitting, outer crank bearings will need replaced. $200

Complete oemclutch , basket plates everything very nice shape $50

Thumb Throttle assembly (tors plug cut off) $10

Rear wheel hubs $40

Brake hub and rotor rear, rotor shows some wear but still useable $10

Orange tank cover and grill plastic $30

Black maier front fenders factory race cuts, and black radiator/grill plastic $40

Rear plastic (painted black) $20

Front plastic cut (painted black) $20

Red front plastic with tank cover and grill/radiator plastic $40

Blue tank cover $10 (cpl stress marks)

Stock seat needs recovered $10\

Kickstart lever and knuckle assembly $20

HEadlight/ run switch works good small peice of Hi/Lo headlight switch broke off still enough there to use $10

Misc hardware/parts lot Pipe hangers, chain adjusters, steering stem clamp/bushing, headlight mounts, engine mounts... all for $20

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...