UPbansheeRacer Posted September 8, 2011 Report Share Posted September 8, 2011 just powder coated my engine what are the nuts for the cylinders and head torqued at Quote Link to comment Share on other sites More sharing options...
bigblockbanshee Posted September 8, 2011 Report Share Posted September 8, 2011 (edited) Edit: Make that 20ft.-lb. Edited September 8, 2011 by bigblockbanshee Quote Link to comment Share on other sites More sharing options...
Infamous039 Posted September 8, 2011 Report Share Posted September 8, 2011 Clymers manual say 20ft lbs Quote Link to comment Share on other sites More sharing options...
dirtydownunder Posted September 8, 2011 Report Share Posted September 8, 2011 starting from the middle and working your way out, torque in steps. 7ft/lb 14ft/lb 20ft/lb then once youve had it hot, let it cool down over night and re torque to 20-22ft/lb Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted September 9, 2011 Report Share Posted September 9, 2011 Criss-cross cyl nuts in stages just like heads, re-torque after heat cycles also Quote Link to comment Share on other sites More sharing options...
camatv Posted September 9, 2011 Report Share Posted September 9, 2011 20 ft lbs. Quote Link to comment Share on other sites More sharing options...
jbooker82 Posted September 9, 2011 Report Share Posted September 9, 2011 snug with a box end wrench. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.